Victron MultiPlus-II 48/5000/70-50 230V GX

Victron MuliPlus-II 48/5000/70-50 230V GX

A MultiPlus-II with LCD and GX functionality
The MultiPlus-II GX integrates a MultiPlus-II inverter/charger and a GX device with a 2 x 16 character display that shows system parameters.

The integrated GX device includes:
• A BMS CAN interface. This can be used to connect to a compatible battery managed via the CAN bus. Please note that this is not a VE.Can compatible connector.
• A USB port.
• An Ethernet port.
• A VE.Direct connection

PowerControl and PowerAssist – increasing grid or generator power
A maximum mains or generator current can be set. The MultiPlus-II then takes other connected AC consumers into account and only uses the remaining current to charge the battery. This prevents the generator or mains connection from being overloaded (PowerControl function). The PowerAssist function takes the PowerControl principle to a new dimension. Load peaks often only occur for a limited period of time. In such a case, the MultiPlus-II immediately compensates for insufficient generator, shore power, or mains power using energy from the battery. If the load is reduced, i.e., consumers are switched off, the then sufficient energy available can be used to charge the batteries.

Solar power: alternating current even in the event of a power failure
The MultiPlus-II can be used in both off-grid and grid-connected PV systems, as well as other alternative energy systems. It can be used with both solar charge controllers and grid-tied inverters.

Two AC outputs
The main output ensures uninterrupted operation. In the event of a grid failure or an interruption in shore/generator power, the MultiPlus-II takes over power for the connected loads. The switchover occurs so quickly (in less than 20 milliseconds) that uninterrupted operation of computers and other electronic devices is guaranteed. The second output only supplies power when AC power is available at the MultiPlus-II input. Loads that must not drain the battery, such as a water heater, can be connected to this output.

Virtually unlimited power through parallel and three-phase operation
Up to six Multis can be connected in parallel for high power requirements. For example, six 48/5000/70 units provide 25 kW/30 kVA output power with 420 A charging capacity. In addition to parallel connection, three units of the same model can also be configured for a three-phase output. But that's not all: by connecting up to six sets of three units in parallel, you can obtain 75 kW/90 kVA of inverter power or 1200 A of charging current. Only one GX unit is required for parallel and three-phase operation.

System configuration, monitoring and control on site
Settings can be changed in minutes using the VEConfigure software (requires a computer or laptop and an MK3 USB interface). Several monitoring and control options are available: Color Control GX, Venus GX, Octo GX, CANvu GX, laptop, computer, Bluetooth (with the optional VE.Bus Smart Dongle), battery monitor, and Digital Multi Control Panel.